CAF - How to fly a P-39, Vintage training film

CAF Centex Wing Museum - How to fly our P-39. Here is a comprehensive vintage US Government training film.

This film is a must for anyone flying our rare P-39 and P-63 vintage flying aircraft.

CAF Centex Wing 's P-39 the "Miss Connie. We also have a flying P-63.

Please note: this is a cockpit photo of our P-63

Official training film. Part 1.

Official training film. Part 2.

Technical Data:

The P-39 was an all-metal, low-wing, single-engine fighter, with a tricycle undercarriage and an Allison V-1710 liquid-cooled V-12 engine mounted in the central fuselage, directly behind the cockpit.

The Airacobra was one of the first production fighters to be conceived as a "weapons system"; in this case the aircraft (known originally as the Bell Model 4) was designed around the 37mm T9 cannon.[28] This weapon, which was designed in 1934 by the American Armament Corporation, a division of Oldsmobile, fired a 1.3 lb (610 g) projectile capable of piercing .8 in (2 cm) of armor at 500 yd (450 m) with armor-piercing rounds. The 200 lb, 90 inch long weapon had to be rigidly mounted and fire parallel to and close to the centerline of the new fighter. It would be impossible to mount the weapon in the fuselage, firing through the propeller shaft as could be done with smaller 20mm cannon. Weight, balance and visibility problems meant that the cockpit could not be placed farther back in the fuselage, behind the engine and cannon.[28] The solution adopted was to mount the cannon in the forward fuselage and the engine in the center fuselage, directly behind the pilot's seat. The tractor propeller was driven via a 10-foot-long (3.0 m) drive shaft which was made in two sections, incorporating a self-aligning bearing to accommodate fuselage deflection during violent maneuvers. This shaft ran through a tunnel in the cockpit floor and was connected to a gearbox in the nose of the fuselage which, in turn, drove the three- or (later) four-bladed propeller via a short central shaft. The gearbox was provided with its own lubrication system, separate from the engine; in later versions of the Airacobra the gearbox was provided with some armor protection.[28] The glycol-cooled radiator was fitted in the wing center section, immediately beneath the engine; this was flanked on either side by a single drum shaped oil cooler. Air for the radiator and oil coolers was drawn in through intakes in both wing-root leading edges and was directed via four ducts to the radiator faces. The air was then exhausted through three controllable hinged flaps near the trailing edge of the center section. Air for the carburetor was drawn in via a raised oval intake immediately aft of the rear canopy.[29][30]

The fuselage structure was unusual and innovative, being based on a strong central keel which incorporated the armament, cockpit and engine. Two strong fuselage beams to port and starboard formed the basis of the structure. These angled upwards fore and aft to create mounting points for the T9 cannon and propeller reduction gearbox and for the engine and accessories respectively. A strong arched bulkhead provided the main structural point to which the main spar of the wing was attached. This arch incorporated a fireproof panel and an armor plate separating the engine from the cockpit. It also incorporated a turnover pylon and a pane of bullet-resistant glass behind the pilot's head. The arch also formed the basis of the cockpit housing; the pilot's seat was attached to the forward face as was the cockpit floor. Forward of the cockpit the fuselage nose was formed from large removable covers. A long nose wheel well was incorporated in the lower nose section. The engine and accessories were attached to the rear of the arch and the main structural beams; these too were covered using large removable panels. A conventional semi-monocoque rear fuselage was attached aft of the main structure.[29][N 5]

Front armament bay

Because the pilot was above the extension shaft, he was placed higher in the fuselage than in most contemporary fighters, which, in turn gave the pilot a good field of view.[28] Access to the cockpit was via sideways opening "car doors", one on either side. Both had wind-down windows; because only the right hand door had a handle both inside and outside this was used as the normal means of access. The left hand door could only be opened from the outside and was for emergency use, although both doors could be jettisoned. In service the cockpit was difficult to escape from in an emergency because the roof was fixed.[31]

The complete armament fit consisted of the T9 with a pair of Browning M2 .50 caliber (12.7 mm) machine guns mounted in the nose. This would change to two .50 in (12.7 mm) and two .30 in (7.62 mm) guns in the XP-39B (P-39C, Model 13, the first 20 delivered) and two 0.50 in/12.7 mm and four 0.30 in/7.62 mm (all four in the wings) in the P-39D (Model 15), which also introduced self-sealing tanks and shackles (and piping) for a 500 lb (227 kg) bomb or drop tank.[22]

Because of the unconventional layout, there was no space in the fuselage to place a fuel tank. Although drop tanks were implemented to extend its range, the standard fuel load was carried in the wings, with the result that the P-39 was limited to short range tactical strikes.[32]

A heavy structure, and around 265 lb (120 kg) of armor were characteristic of this aircraft as well. The production P-39's heavier weight combined with the Allison engine having only a single-stage, single-speed supercharger, limited the high-altitude capabilities of the fighter. The P-39's altitude performance was markedly inferior to the contemporary European fighters and, as a result, the first USAAF fighter units in the European Theater were equipped with the Spitfire V. However, the P-39D's roll rate was 75°/s at 235 mph (378 km/h)– better than the A6M2, F4F, F6F, or P-38 up to 265 mph (426 km/h). (see NACA chart).[33]

Above the supercharger's critical altitude of about 12,000 ft (3,658 m), an early P-39's performance dropped off rapidly. This limited its usefulness in traditional fighter missions in Europe as well as in the Pacific, where it was not uncommon for Japanese bombers to attack at altitudes above the P-39's operational ceiling (which in the tropical hot air was lower than in moderate climates). The late production N and Q models, making up 75% of all Airacobras, could maintain a top speed of approximately 375 mph (604 km/h) up to 20,000 ft (6,100 m).

The weight distribution of the P-39 was supposedly the reason for its tendency to enter a dangerous flat spin, a characteristic Soviet test pilots were able to demonstrate to the sceptical manufacturer who had been unable to reproduce the effect. After extensive tests, it was determined the spin could only be induced if the aircraft was improperly loaded, with no ammunition in the front compartment. The flight manual noted a need to ballast the front ammunition compartment with the appropriate weight of shell casings to achieve a reasonable center of gravity. High speed controls were light, consequently, high speed turns and pull-outs were possible. The P-39 had to be held in a dive since it tended to level out, reminiscent of the Spitfire. Recommended dive speed limit (Vne) was 475 mph (764 km/h) for the P-39.[34]

Soon after entering service, pilots began to report that “during flights of the P-39 in certain maneuvers, it tumbled end over end.” Most of these events happened after the aircraft was stalled in a nose high attitude with considerable power applied. Concerned, Bell initiated a test program. Bell pilots made 86 separate efforts to reproduce the reported tumbling characteristics. In no case were they able to tumble the aircraft. In his autobiography veteran test and airshow pilot R.A. “Bob” Hoover provides an account of tumbling a P-39. He goes on to say that in hindsight, he was actually performing a Lomcevak, a now common airshow maneuver, which he was also able to do in a Curtiss P-40.[35] [N 6] An informal study of the P-39’s spinning characteristics was conducted in the NASA Langley Research Center 20-foot Free-Spinning Tunnel during the 1970s. A study of old reports showed that during earlier spin testing in the facility, the aircraft had never tumbled. However, it was noted that all testing had been done with a simulated full ammunition load, which drew the aircraft’s center of gravity forward. After finding the original spin test model of the P-39 in storage, the new study first replicated the earlier testing, with consistent results. Then, the model was re-ballasted to simulate a condition of no ammunition load, which moved the aircraft’s center of gravity aft. Under these conditions, the model was found to often tumble when thrown into the tunnel.[37]

The rear-mounted engine made the aircraft ideal for ground attack since fire would be coming from the front-bottom quarter and was less likely to hit the engine and its cooling systems. The arrangement proved to be very vulnerable to attacks from above and behind and nearly any hit on the fuselage from an attacking enemy fighter was virtually guaranteed to disable the cooling system and lead to the prompt demise of the engine and thus the aircraft. Flying at its upper altitude limits, the Airacobra was extremely vulnerable to any enemy fighter with decent high altitude performance.

For More in formation on The Central Texas Wing of The Commemorative Air Force 

Please visit our website.